View Cart Checkout
The Original Freddy
Support
 

Assembly Instructions

STEP 1
Using two of the bolt assemblies, attach the cushioned crossbars onto the right side panel. Make sure you attach them to the black side so that Freddy is facing outward. To prevent racking, do not tighten the bolts yet.
STEP 2
Now turn the chair so that the right side panel is flat on the floor. Using the remaining bolt assemblies, attach the left side panel to the crossbars. Again, do not [over] tighten the bolts.
STEP 3
Stand Freddy upright to level the side panels with the csbars and then tighten the bolts until the panels are completely secure. Use the spot stickers to cover the four countersink holes.
STEP 4
Compress your Loop to reduce its width as much as possible. While holding both ends, slide the Freddy Loop over the left side panel’s tail and/or legs. Be sure to keep the Loop bunched up tightly against the left side panel as you slide it on.
STEP 5
Work the Loop over the top of Freddy’s Head. Sliding it over his head will be snug, but as long as the entire sling is kept tightly pressed against the left side panel, it should slide on without difficulty.
STEP 6
Spread the Loop over the crossbars and center it then position it for optimal comfort and support. If you have issues regarding the application of the Freddy Loop, please visit our web site for further instructions.